Fishing The Fly Scotland Forum

Iain Goolager

Rod building mod's
« on: 24/11/2011 at 21:05 »
converting a Fladen 4 piece rod into a 2 1/4 piece and have a couple of questions;

a) Can I shorten a section by just simply hacksawing the monkey or should I wrap a section of tape around the blank and cut through this, or some other form of treatment?
b) Am I being miserable if I decide to use the existing reel seat assembly & what are the chances of getting it out alive?

Thanks

Iain

Peter McCallum

Re: Rod building mod's
« Reply #1 on: 25/11/2011 at 01:00 »
Masking tape and used the old fittings it worked for me :grin

Derek Roxborough

Re: Rod building mod's
« Reply #2 on: 07/12/2011 at 21:42 »
 I often take reel seats off by putting a hot rod up inside the seat , if you hold the hot rod in the vice,as soon as you can move the seat remove the rod from the hot rod, that way you dont burn the rod, I have salvaged quite a few seats from broken rods, and from decent rods, easgach1

Iain Goolager

Re: Rod building mod's
« Reply #3 on: 07/12/2011 at 21:52 »
Hi Easgach1  :z16

No fancy tools/ operation was required. Dry palms and a good set of 'guns' twisted it off fairly swiftly.  :X4

 Iain

Derek Roxborough

Re: Rod building mod's
« Reply #4 on: 08/12/2011 at 16:35 »
Well done, it always depends how it was put on,I have used the hot rod method to successfully recover whole cork handles, easgach1

 




Barrio Fly Lines - designed in Scotland - Cast with confidence all over the world

Barrio Fly Lines

Designed in Scotland

Manufactured in the UK

Cast with confidence all over the world

www.flylineshop.com