Fishing The Fly Scotland
Index => Barrio Fly Lines => Topic started by: John Powell on 16/02/2017 at 14:00
-
hi
bought an un-used Mallard WF-6-ST from a member on FFF
used yesterday on a stillwater - well actually a bit choppy in a 10mph wing
cast perfectly, felt smooth, lay straight as a straight thing --- well pleased.
BUT - the ST took about 20 casts before it began to sink and then was fine
some floatant transfered maybe off the main line which I treated with Snowbee LineSlick
what the best way to clean - soapy water.?
-
Hi John,
Yes, clean the sink tip section with soapy water, it can take a while to remove line treatments once they've been applied.
Line treatments can cause an intermediate line/section to float, but it could just be a new line, new lines usually take a wee while to start sinking properly.
Best wishes
Mike